P2131 DODGE code

Well the P2131 code is defined as a Throttle/Pedal Position Sensor/Switch “F” Circuit. This code is set by the PCM when it finds a fault in the throttle position sensor. We will give you more information about this code and also on how to resolve it, so simply read along.

What can cause a P2121 code?

What causes the P2121 code?

  • Defective throttle actuator control motor.
  • Defective throttle position actuator.
  • Defective throttle position sensor or pedal position sensor.
  • Corroded, open or shorted wiring or connectors in throttle actuator motor or Controller Area Network (CAN) bus harness.
  • Loose control module ground strap.

What is the code for TPS?

P0120 is a diagnostic trouble code (DTC) for “TPS “A” Circuit Malfunction”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.

What is code P2125 mean?

P2125 is a general OBD-II trouble code indicating a fault with the throttle/pedal position sensor/switch “E” circuit. This code is similar to many other throttle body and pedal position codes.

How do I fix error code P2122?

What repairs can fix the P2122 code?

  1. Replacing or repositioning a ground wire.
  2. Replacing the wiring and/or connectors in the CAN bus harness or throttle actuator motor.
  3. Replacing the throttle position sensor, the throttle actuator control motor, the throttle position actuator, or the pedal position sensor.
  P1000 DODGE code

How do I fix error code P2127?

What repairs can fix the P2127 code?

  1. Repair or replacement of the wiring harness for the throttle position sensor or pedal position sensor.
  2. Throttle/Pedal position sensor E replaced.
  3. Fixing the intermittent electrical connection.
  4. ECM replacement if required.

How do you reset a throttle position sensor?

The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.

How do I reset my electronic throttle?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.