P2104 FORD code

Code P2104 is an indication that the ECM is in failure management mode and has limited the RPM of the engine since the throttle control actuator system has a failure. The problem may be in another system as well causing a problem.

How do you fix a throttle actuator control system?

What repairs can fix the P2111 code?

  1. Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
  2. Clean the throttle body. …
  3. Replace the throttle body. …
  4. Replacing the PCM. ( …
  5. Repair the wiring.


What is throttle actuator control system forced idle?

The throttle actuator control system controls the functioning of the throttle valve and plates to respond to the driver’s request while accelerating. If the control system senses any problem with the throttle response, it puts the throttle into forced idle condition and limits the engine to idle RPM condition.

What is a throttle actuator control module?

Product Description. An ACDelco GM Original Equipment Fuel Injection Throttle Control Actuator Module is an electrically operated motor assembly that controls the throttle plate(s), and is a GM-recommended replacement for your vehicle’s original component.

  P0299 FORD code

How do I fix error code P2107?

What repairs can fix the P2107 code?

  1. Repairing or replacing throttle body actuator wiring harness.
  2. Replacing throttle body.
  3. Fixing poor electrical connection.
  4. Replacing throttle position sensor.


How much does it cost to replace a throttle actuator control system?

The throttle body part will typically cost between $200 and $500, depending on the type of car that you drive. Labor costs for this kind of repair are typically relatively low, so you can expect to pay between $50 and $150 to have the part professionally installed.

Where is throttle actuator control located?

The throttle controller is located on top of the engine between the air intake and the intake manifold.

What causes P2104 code?

What causes the P2104 code? The engine control module is in failure management mode from a major failure in the throttle actuator control system and sets code P2104 for limiting the engine to idle closed throttle only.

How do I fix error code P2106?

How To Correct P2106 Throttle Actuator Control System – Forced Limited Power

  1. Throttle position sensor replacement.
  2. Accelerator pedal sensor replacement.
  3. Throttle control system reprogramming.
  4. PCM repair and reprogramming.
  5. Faulty wiring and connector replacement.


How do I fix error code P2110?

It’s best to replace the damaged ECU with a new one to avoid further malfunctioning of the vehicle. Throttle system – The check engine light will stay on if the throttle system is faulty. Replace it quickly to avoid the P2110 error in your vehicle.

How do I clean my throttle actuator control?

Zitat von Youtube: Remember pull the tab. Push. It in to the component. And then remove it the throttle body itself is held in with four bolts for this.

  P0420 FORD code

How do you test a throttle actuator control module?

Zitat von Youtube: Between terminals a and b of the throttle actuator motor. If the throttle actuator motor is okay the resistance value should be around 2 to 15 ohms.