P2008 CHRYSLER code

P2008 means that the intake manifold runner circuit has an open electrical connection bank 1. The ECU tries to control the the angle of the intake manifold runner flappers and when it cannot control this circuit sets a Check Engine Light.

How much does it cost to replace a intake manifold runner control?

A new intake manifold runner valve can cost anywhere between $50 and $200, depending on factors like its brand and your vehicle’s specifications. Labor costs for replacing a damaged intake manifold runner valve typically range from $300 to $400.

How do I replace intake manifold runner control?

How to replace an intake manifold runner control

  1. Extract the engine trim cover from the engine.
  2. Remove the faulty intake manifold runner control.
  3. Install the new intake manifold runner control.
  4. Reinstall the engine trim covers.
  5. Examine the engine to ensure the safety of the new equipment.

What does intake manifold runner control stuck open bank 1 mean?

Essentially, this is the part that controls how fuel gets pumped into the part of the engine that combusts fuel to produce power. This system is controlled by the powertrain control module, which means if the actuator is stuck open, it might be a problem with either the intake manifold or the powertrain control module.

  P0712 CHRYSLER code

What does the intake manifold runner control do?

The basic function of intake manifold runner control is to reduce or divert airflow through certain intake runners for better high-rpm performance and reduced emissions. In practice, many aftermarket ECUs disable the solenoid valves responsible for the IMRC system.

How do I fix code P2008?

What repairs can fix the P2008 code?

  1. Intake manifold runner flaps unstuck.
  2. Wiring harness replaced or repaired as needed.
  3. Intake manifold runner control solenoid replacement.
  4. Repair of poor electrical connection.

How long does it take to replace the intake manifold?

Registered. Took me about 45minutes to get it off the first time. It takes longer to get it back on, burp the coolant system, and replace the parts you need. Plus paint/powdercoating.

Where is intake manifold runner control located?

Above and behind the serpentine belt, you’ll find a black box with linkages coming out of it. The box contains an electric motor that controls two doors or flaps in the side of the intake manifold [Ford calls it the Intake Manifold Runner Control].

Where is the intake manifold actuator?

The Intake Manifold Actuator is mounted on an Intake Manifold that acts as a passage of air that is sucked into the cylinder of the engine.

Where is the Imrc located?

Step 2: Locate the IMRC.

Often, it’s bolted directly to the top of the intake manifold or at one end or the other. Sometimes it is bolted in a remote location, like the valve cover, and will use a cable connection to the intake flaps.

  P0420 CHRYSLER code

Where is the intake manifold runner position sensor Bank 1?

Code P2015 stands for Intake Manifold Runner Position Sensor Range Bank 1. The intake manifold sits on top of the engine between the cylinder heads.

Can I drive with P2004?

Is it safe to drive with P2004 code? It is safe to drive, Because the CK ENG LT is on you would use more fuel than required, This code condition is also capable of suspending any other code that may appear.