P1607 DODGE code

December 30, 2020. If You’re seeing fault code P1607 on a 2007 Dodge Caliber (or any other Dodge vehicle for that matter), then You’re likely in for some bad news. It means that Your Powertrain Control Module (PCM) has internal shutdown timer slow rationality issues.

What does p1607 mean?

Zitat von Youtube: P1607 is a diagnostic trouble code for powertrain control module internal circuit malfunction. Under this circumstance stop driving and repair your vehicle immediately.

What does PCM internal shutdown timer rationality mean?

Set Condition:



Upon power up, the PCM compares the change in engine coolant temp sensor since last engine shut down and compares it to the amount of time the engine was turned off. If not enough time has occurred to account for the difference in engine coolant temperature then the fault will set. Two Trip Fault.

What does code po700 mean?

The P0700 code indicates that there’s a malfunction with your vehicle’s Transmission Control Module (TCM). This computer monitors your transmission and works with the Powertrain Control Module (PCM) and Engine Control Module (ECM) to shift gears when necessary.

How do you fix P0700 transmission control system malfunction?

What repairs can fix the P0700 code?

  1. Transmission control module (TCM) replacement.
  2. Repairing or replacing faulty wiring.
  3. Valve body replacement.
  4. Transmission shift solenoid replacement.
  P0202 DODGE code


Can I drive with code P0700?

P0700 could indicate serious transmission problems or the future of the transmission. This code can cause serious driving problems, so caution should be exercised. Do not drive the vehicle if it has shifting problems or if it is stuck in gear, as this will cause further damage and pose a road safety hazard.

How much does it cost to fix a P0700?

How much will it cost to fix? The cost to repair this issue will depend on your car’s make and model. However, the average cost to replace your car’s TCM is $500 to $900. Labour typically costs $75 to $150 per hour, while the part itself ranges from about $450 to $700.

How do you fix a stuck shift solenoid?

What Repairs Will Fix P0752?

  1. Changing the transmission fluid and filter.
  2. Replace faulty solenoid.
  3. Repair or replace a faulty transmission pump.
  4. Repair or replace defective transmission valve body.
  5. Perform transmission flush to clean passages.
  6. Cleaning corrosion from connectors.
  7. Repairing or replacing wiring.

Can low transmission fluid cause a p0700 code?

The P0700 code can also be seen if the fluid is low or the transmission is failing. If the TCM does not communicate with a TCM compatible scan tool, the TCM may be faulty and need to be replaced. However, it is rare that the TCM is faulty. It’s most likely something within the transmission or electrical system.

How do you reset a transmission control module?

To reset the TCM, I turn the key to the ON position, step on the accelerator pedal for 10 seconds, turn off the engine, release the accelerator pedal and wait 5 minutes for the engine to restart.

  P0303 DODGE code