P1345 KIA code

What a P1345 code means. The powertrain control module (PCM) compares the crankshaft position (CKP) sensor data to the camshaft position (CMP) sensor information to ensure the two shafts are where the PCM expects them to be. This is especially important on vehicles with variable valve timing (VVT).Jan 17, 2018

How do I fix code P1345?

To do so, follow these steps:

  1. Loose the distributor hold down bolt with engine OFF.
  2. Make sure your OBD scanner is plugged in to monitor the Cam Retard Offset reading.
  3. Turn the engine on, let it warm to normal operating temps, and get the rpm’s above 1,000.
  4. If your reading is negative, turn the distributor counterclockwise.

What causes code P1345?

Toyota and Lexus specifies that fault code P1345 is indicative of a variable valve timing sensor-related issue, on the engine’s left-hand bank. Alternatively, both Audi and Volkswagen state that DTC P1345 denotes a short to ground condition, within a vehicle’s ignition amplifier circuit.

How do you relearn a crankshaft sensor?


Zitat von Youtube: Cut release the accelerator pedal. So it's just one quick throttle turn the ignition switch off I'm gonna turn that off right now.

Where is the crankshaft sensor located?

The sensor is at either the front or the back of the crankshaft, so it’s usually located either on the transmission bellhousing or behind the crankshaft pulley. There should be a small air gap, usually about a millimeter or two, between the sensor and the reluctor.

  P0708 KIA code

Will disconnecting battery reset crankshaft sensor?

disconnect the battery from the positive battery terminal, wait for the vehicle to sit for an hour, and then reconnect the battery to the engine light, to reset the indicator light. It is usually a faulty crankshaft position sensor that will cause the vehicle to stall whenever it is in use, or not start entirely.

How long does it take for a crankshaft sensor to reset?

This can take up to 10 minutes. Do not turn off the engine or disconnect the scan tool during this procedure. Remove the scan tool. Turn the engine off, then back on again.