P1100 GMC code

P1100 code definition A P1100 trouble code is stored when the Powertrain Control Module (PCM) detects a Mass Air Flow (MAF) sensor signal that falls above or below the manufacturer calibrated limits.

How do I fix code P1101?

What repairs can fix the P1101 code?

  1. Replace or repair any faulty, damaged, or loose wiring, connectors, or components within the MAF sensor harness.
  2. Clean or replace the air filter if it is dirty.
  3. Clean the MAF sensor with specialized cleaner. …
  4. Repair any leaks within the vacuum system.

What are the Harley-Davidson codes?

Diagnostic Trouble Codes (DTCs) and Fault Conditions

DTC PRIORITY ORDER FAULT CONDITION
B1305 345 Faceplate power/mute button stuck
B1306 399 Rear hand controls shorted high
81307 400 Rear hand controls shorted low
81308 401 Rear volume up button stuck

How do you read a Harley-Davidson code?

Zitat von Youtube: So P is ECM code you click to get to this then you hold down to enter into what codes might be under the P this bike has none click it again it'll run the part number of the ECM.

How do you read a Harley-Davidson 2020 code?

Zitat von Youtube: First we're gonna start by pulling the switch down here we'll zoom in on this a minute. And then we're going to hold that down turn the ignition. On.

  P0B50 GMC code

How do I clear Harley error codes?

Zitat von Youtube: You'll notice all the gauges. Go to the right. And they'll come back to the left. You can release that odometer button and you'll notice that it says diag.

What is BCM on a Harley?

Custom Dynamics® Dynamic Load Isolator (DLI) for Harley-Davidson® uses the latest technology to isolate the motorcycle’s Body Control Module (BCM) allowing for the use of almost any aftermarket lighting product or electrical accessory.

What does FLH Harley stand for?

by Rob Wagner. Harley-Davidson Motor Company. The Harley-Davidson FLH motorcycle, manufactured by the Milwaukee-based Harley-Davidson Motorcycle Company, originated in 1949 as the Hydra-Glide touring model, so named for its hydraulically damped telescopic forks.

What does the red key light mean on a Harley?

Only show this user. If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car.