P0772 MERCEDES-BENZ code

P0772 code definition When the Powertrain Control Module (PCM) detects a problems in the shift solenoid, usually in the form of an incorrect gear ratio, a P0772 trouble code is stored.

How much does it cost to fix a shift solenoid?

$200 to $500

Shift Solenoid Repair and Replacement Cost
The overall cost to replace the shift solenoid in an automatic transmission ranges from $200 to $500 for a single solenoid. If the damage requires you to replace the entire solenoid pack the cost increases to between $250 and $700.

What is shift solenoid E?

Generic transmission diagnostic trouble code (DTC) P0770 stands for “Shift Solenoid “E” Malfunction.” This code indicates that your PCM has detected a malfunction in your transmission within your shift solenoid shift circuit, which is identified by designation “E.” Your automatic transmission depends on multiple moving …

What does P0773 code mean?

What the P0773 code means. The transmission control module (TCM) turns shift solenoid valve E on or off depending upon the operating conditions of the vehicle. If there is a malfunction somewhere in the wiring or solenoid itself, it will cause abnormality in the gear ratio, causing P0773 to set.

  P0272 MERCEDES-BENZ code

What is code po974?

P0974 code definition

The P0974 code is generic powertrain code related to the transmission, including pressure faults and sensor failures. In this case, the engine control module (ECM) has detected a fault with a high voltage reading from the shift solenoid A control circuit.

Can you replace a shift solenoid yourself?

Shift Solenoid: REPAIR INFORMATION

Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

Where is shift solenoid located?

Transmission Shift Solenoid Location

The Transmission shift solenoids are located inside the valve body of your automatic transmission. They are integrated into the valve body, and on some car models, you can see them without removing the valve body, while on others, you have to remove the valve body to reach them.

How many solenoids are in a transmission?

there are two or more shift solenoids inside your transmission. the solenoids are typically integrated into the transmission valve body. if one or more of them fails, you’ll likely notice a handful of car problems.

How do you fix a shift solenoid B malfunction?

The most common repair for the P0755 code is replacement of the shift solenoid circuit.
However, other repairs may include:

  1. Replacing a failed shift solenoid.
  2. Topping off low fluid.
  3. Changing burned, dirty fluid.
  4. Replacing or repairing a damaged wiring harness.

What is the shift solenoid C?

Shift solenoids are vital to the functioning of your vehicle’s computer-controlled automatic transmission. It uses them to manage the movement of fluid between various hydraulic circuits and activate a change in transmission gear ratio when necessary.

  P0139 MERCEDES-BENZ code

How do I fix code P0733?

Repairs that can fix a P0733 code would include:

  1. Replacing a shift solenoid.
  2. Replacing the powertrain control module.
  3. Replacing the transmission module (if applicable)
  4. Adding or replacing the transmission fluid and filter.
  5. Overhauling the current transmission.
  6. Installing a brand new transmission.

What is code P0770?

P0770 is an OBD-II generic code for a malfunction of shift solenoid E on the transmission valve body. This controls the supply of hydraulic pressure to the lock-up clutch of the torque converter that creates a one-to-one ratio for both input and output transmission speeds.