P0514 DODGE code

The P0514 code indicates that there is a malfunction in the battery temperature sensor.

Where is the battery temperature sensor located?

Attach the battery temperature sensor in the center of the battery-storage system, in the upper third of the battery cell. As a result, the battery temperature sensor measures the temperature at the warmest point in the battery-storage system.

What is a battery temperature sensor?

A battery temperature sensor is also called the electronic battery sensor (EBS) or intelligent battery sensor (IBS) in some vehicles. This sensor is typically a thermistor by nature, meaning that it measures resistance in a circuit based on the ambient temperature.

How do you test a battery temperature sensor?


Zitat von Youtube: For the past decade many vehicles have been using battery temperature sensors as a way to measure battery performance the sensor can be attached to the battery or the tray.

Do I need a battery temperature sensor?

What can happen if you don’t have a temperature sensor? If the battery temperature is low, then the full voltage point will be lower. However, the charge controller will unwittingly continue to try to raise the voltage level – causing your batteries to over charge, off-gas and eventually damage the batteries.

Will a bad battery current sensor symptoms?

When the battery current sensor fails, the vehicle will not charge correctly, leading to a DTC or a dead battery. Common signs of failure include: Irregular charging rates. Low battery voltage.

  P0841 DODGE code

Can you bypass a battery sensor?

If a car has a battery current sensor and additional electrical accessories are connected directly to the battery negative terminal, it may cause problems, because the electric current will bypass the battery current sensor and its readings won’t be accurate.

How do you install a battery temperature sensor?

To install a BTS:



1. Switch off all devices operating from the battery. 2. Connect the ring terminal on the sensor directly to the negative battery stud, or use the adhesive backing on the sensor back to attach the sensor to any side of the battery to be monitored.

What does a Dodge battery sensor do?

The sensor informs the car of the exact battery status, measures the temperature and controls the charging voltage and charging current accordingly.

How do I disconnect the battery sensor?

Zitat von Youtube: Angezogen.