P0353 BUICK code

The P0353 code is a generic powertrain code related to the ignition system or an engine misfire. In this case, a malfunction has been found specifically in ignition coil C (or number 3) in the primary or secondary circuit. Codes related to the P0353 include: P0351: Ignition Coil Primary/Secondary Circuit.

How do I fix error code P0353?

How Is Code P0353 Fixed?

  1. Replacing ignition coil C.
  2. Replacing the coil pack, wiring, and connectors.
  3. Replacing the spark plug and spark plug wire.
  4. Repairing or replacing an ignition coil C connector.
  5. Repairing any other electrical wiring or coil connection faults.
  6. Repairing the vacuum leak.
  7. Repairing or replacing the PCM.


What is ignition coil B secondary circuit location?

Code P0352 indicates a malfunction with the primary side (next to the onboard computer) or the secondary side (next to the spark plug) of ignition coil B. The ignition coil B (or coil number 2) is located above cylinder number 2 of your vehicle’s engine.

What is coil C primary secondary circuit?

This DTC refers to an electrical problem with Ignition Coil “C” (which is the coil located at the #3 cylinder) or its circuit. The P0353 code may trigger from an issue detected from the primary (computer) side or secondary (spark plug) side of the circuit.

  P0133 BUICK code

What is ignition coil a primary secondary circuit malfunction?

The P0351 DTC is seen when the ignition coil A primary or secondary circuit has a malfunction. The engine control module is looking for specific signals from the ignition coil A and when these signals are not seen the ECU sets the Check Engine Light. The Check Engine Light will be illuminated on the dashboard.

Where is ignition coil located?

The ignition coil sits between the battery and, if the car is an older model, the distributor that ‘distributes’ the HT voltage it produces to each spark plug, via thick rubbery HT leads (one per plug).

What does misfire on cylinder 3 mean?

Cylinder 3 misfires can be caused by many reasons from a faulty ignition system, fuel system, or internal engine failure. The most common reason for this to happen is faulty or worn-out spark plug coil packs, especially if it’s been a while since you had a tune-up. Faulty or worn spark plugs.

How do I fix code P0352?


Zitat von Youtube: If you are getting a p0352 error code this video is going to show you one practical solution to fix the error code at home use the zeus app to scan your vehicle. And see the error code po352. It

How do you test a ignition coil?

Zitat von Youtube: And simple test that can be done you use a circuit test which is also called a test lighting. And what you do you connect the negative up to the negative cable still disconnected.

What does it mean when cylinder 4 is misfiring?

Cylinder 4 misfires can be caused by many reasons from a faulty ignition system, fuel system, or internal engine failure. The most common reason for this to happen is faulty or worn-out spark plug coil packs, especially if it’s been a while since you had a tune-up.

  P140C BUICK code

What is DTC code for ignition coil primary circuit?

Code P0351 is defined as “Ignition Coil ‘A’ Primary/Secondary Circuit Malfunction.” It’s an OBD-II diagnostic trouble code (DTC) that indicates a fault with ignition coil ‘A’ (a problem with the coil on cylinder #1 or its circuit).

How do I fix code p0302?

Zitat von Youtube: If the ignition coil is covered with engine oil or stains. Simply clean it with a wd-40 cleaner otherwise replace the damaged ignition coil with a new.