Mazda 626 1995 automatic won’t shift gears

What would cause the transmission not to engage?

Transmission won’t engage or stay in gear



If when you put your vehicle into gear and it won’t move, this may be a problem with low transmission fluid due to a leak, the shifter, shifter cable, or it could even be a problem in the valve body of your automatic transmission.

What causes an automatic car not to engage gears?

One reason why an automatic transmission isn’t shifting into gear has to do with the fluid. If it’s not at the right level or the incorrect type has been used, then it’ll affect the gears. Another big reason has to do with the ECM possibly going bad.

Why is my car in reverse but not moving?

If your car changes into reverse but won’t move or won’t shift into reverse at all, inspect for a low transmission fluid level. When your vehicle’s transmission fluid level is low, it causes insufficient lubrication, which leads to overheating of the transmission gears.

Why can I move my shifter but it won’t move into gear?

If you are unable to actually change gears, the possibility of damage to the linkage between the shift lever and the gearbox has to be ruled out first. The linkage might appear to move but it might not be moving to the required extent.

Is there a fuse that controls transmission?

The transmission control module can often be found below the cover at the back of the transmission case. It should be just below the engine control module’s position.

How do I reset my transmission?


Past the kickdown switch. Hold it for ten seconds. And then keep it down turn the key back off then release it and then wait two minutes do not do anything.

Why wont my car Let me put it in drive?

There are a number of reasons why a car will not move from park to drive. They can range from the shifter being locked, to a broken shifter cable. Here are a few of the most common conditions that will keep your car stuck in park. Locked shifter: A shifter will sometimes get locked in park.

What causes a gear shifter to lock up?

Slamming into gear, or frequent speed shifting can all cause wear and tear. A stretched cable won’t do the job effectively, and will eventually get stuck. Sometimes your vehicle is unable to read the signals coming from the sensors. These sensors are what helps your vehicle determine when to switch gears.

How do I know if my shifter cable is bad?

If you suspect yours is failing, watch for the following symptoms.

  1. Indicator doesn’t match the gear. If the shift selector cable is going bad, the indicator light or cable will not match the gear you are in. …
  2. Vehicle will not turn off. …
  3. Vehicle starts in another gear. …
  4. Vehicle will not go into gear.


How do you test a transmission cable?

There is a quick test you can perform. If the vehicle doesn’t go into any gear, shift the transmission into neutral and try to push the vehicle a couple feet. If you can only rock the vehicle, but your indicator says neutral, the cable is probably broken.

How much does it cost to replace a shifter cable?

between $303 and $349

The average cost for automatic trans shift cable replacement is between $303 and $349. Labor costs are estimated between $177 and $223 while parts are priced at $125. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.

Where is the transmission shift cable located?

The shift selector cable connects the gear shifter, located on the steering column or on a floor mounted console, to the automatic transmission. The cable is typically steel and is protected from the elements by a plastic outer sheath.

What connects the shift cable to the transmission?

The shift cable runs up through the firewall and attaches to this lever. The cable runs from the firewall to the transmission gear shift linkage, where it is attached and held securely in place. As the handle is moved, it either pulls or pushes on the cable. In turn, the cable does the same to the transmission linkage.

How long does it take to replace a shift cable?

The time it takes to replace a shift cable will vary across car make and model. On average, the shifter cable takes 1.5-2 hours to install. If the whole cable does not need to be replaced, other repairs on the same part may take less time to complete.