I just changed my transmission in my 2008 Altima and im having codes pop up

How do you reset the transmission on a Nissan Altima?

Press and hold the brake pedal, then press and release the gas pedal. The A/T CHECK light should flash on and off in a pattern. Put the shifter in park, and turn off the car. When You restart the car, the TCM will be reset.

How do you find the engine code on a Nissan Altima?

Turn on the ignition key and press the Trip and Reset buttons on the odometer. Your odometer’s display may reveal a Diagnostics Trouble Code or DTC when you turn the key ON and then release the odometer Reset and Trip buttons.

What does at check light mean on a Nissan Altima?

9,205. Lars answered 9 years ago. The autimatic transmission has failed in some way or other making it impossible for the computer to tell whether it’s in gear or not thus not allowing the engine to turn over. You will need to get your car over to a dealership to have it diagnosed.

Does Nissan Altima have transmission problems?

Owners and lessees of Nissan Altima vehicles have reported several recurring problems with the CVT transmissions, including lurching, acceleration issues, vehicle overheating and premature transmission failure.

How do you reset the transmission control module on a Nissan?

How to reset a transmission control module Chevy

  1. Step 1: Turn key position. The first thing you want to do is place your key in the ignition and turn it twice so all of the lights on the dashboard illuminate. …
  2. Step 2: Foot on the gas pedal. …
  3. Step 3: Turn key off and release gas pedal. …
  4. Step 4: Wait. …
  5. Step 5: Ready to drive.

How do you reset the transmission light on a 2008 Nissan Altima?


  1. Turn AC off.
  2. Move the shift selector to the Park position, turn ignition off, then wait 5 seconds.
  3. Start the engine and allow it to idle for 5 seconds.
  4. Turn the ignition off and wait 30 seconds.
  5. Perform steps 4 and 5 two more times for a total of three cycles.
  6. Restart the engine.

What does the service engine soon light mean on a 2008 Nissan Altima?

A red light indicating trouble in the engine’s checking engine or service engine is an indication of problem with it. Several possible causes may include an engine problem causing the catalytic converters to fail. It is strongly advised that you get your vehicle serviced instantly if it detects a blinking engine light.

How do I check my check engine light code without a Nissan?

Press the odometer’s Trip and Reset buttons while turning the ignition key ON. After turning the key ON, release the odometer Reset and Trip buttons to check if the Diagnostic Trouble Code or DTC appears on the odometer display.

How do you reset the check engine light on a Nissan?

Turn on the ignition switch, but don’t start it while you’re seated in the driver’s seat. Just hold down the button for exactly three seconds. For example, make sure you hit the accelerator every fifth time. At exactly 7 seconds, take your foot off the accelerator.

Is there a recall on 2008 Nissan Altima transmission?

A Nissan Altima transmission recall has never been issued.

What is the most common problem with Nissan Altima?

The worst problems with the Altima have to do with its continuously variable transmission (CVT). Owners complain about delayed throttle response and feeling a shudder or jerking sensation when accelerating. Some models have even had transmission failure.

What causes Nissan transmission problems?

Nissan transmissions tend to run hot due to a lack of adequate transmission fluid cooling. Overheating can cause premature transmission failure. If the transmission overheats, the transmission module detects this condition and puts the vehicle in fail-safe mode.

Is there a recall on Nissan transmissions?

Summary: This Nissan Altima CVT recall and Nissan Rogue recall applies to vehicles equipped with the RE0F10A Nissan CVT transmission. Nissan voluntarily recalled these vehicles to address a number of drivability complaints.

What is Nissan CVT transmission problems?

Reported issues include loss of power, transmission jerking, transmission slipping, CVT coolant hose leaks and failures, and a CVT error message being displayed. These problems call the Nissan CVT transmission reliability into question and can result in serious harm to unsuspecting drivers.

What years did Nissan have transmission problems?

Generally, the issues have been reported between 2012/. There were some problems in 2003 when Nissan first began using this transmission and in the 2007-2012 CVT generation. Specific models include the Murano, Sentra, Altima, Rogue, Versa, and Versa Note.

Who has the worst CVT transmission?

But Nissan’s CVTs are also known for failing early on, which is why they’re the subject of many lawsuits. The transmissions are notorious for shuddering, making strange noises, overheating—and forcing the vehicle into a “limp” mode. Some would argue that Nissan’s CVTs are the worst transmissions ever built.

How do I know if my Nissan CVT is bad?

  1. Symptoms of a bad CVT Transmission.
  2. Unusual Noises – There may be noise coming from the CVT transmission. …
  3. Slipping Gears – a very common symptom of a bad CVT transmission is that the transmission is slipping gears. …
  4. Muddy Fluid – Muddy fluid or debris filled fluid could be a symptom of bad CVT transmission.