How to remove a tailgate strut that do not have a c-clip


How do you remove a tailgate strut?

How to Replace Tailgate Struts (4-Step Guide)

  1. Remove old struts.
  2. Remove bolts.
  3. Remove the upper mounting bolt.
  4. Replace the two bolts with the new ones provided with your gas strut.


How do you pop off gas struts?

Use a flathead screwdriver to remove the lift support clips. Once removed you can pull the ball of the strut off the joint and remove the strut out of the car. With the strut removed, you can move on to the second step of the process.

How do you replace trunk struts?

How to Replace Trunk Strut

  1. Open the trunk. Photo may not be specific to your vehicle.
  2. Prop open the trunk.
  3. Remove the retainer bolts from the top and unscrew lower end of the old shocks. …
  4. Remove the weak trunk strut. …
  5. Install the new strut. …
  6. Remove prop rod.
  7. Inspect and test the trunk to verify the trunk strut repair.


How do you remove a strut?

Remove the Strut Mount Nuts



Place a thin piece of plywood under the strut flange to prevent it from damaging the CV boot once you disengage the top portion of the strut. Use a ratcheting wrench or socket/ratchet to loosen the strut mount nuts located on the strut tower. Loosen all of them and remove all but one.

Can you repair tailgate gas struts?

In just a few quick, straightforward steps, you’ll be able to fit your own gas struts, removing your old ones and replacing them with the correct, new version.

How long do tailgate struts last?

How long do hydraulic struts last? On average, if your car has been “babied,” you can expect your shocks/struts to last about 10 years. If you have really used your car like a workhorse, 5 years is probably all you can expect.

How do I remove a ball socket?

antennamediatorino.eu
Part. So I took this cap off prying. This off. And then once you have this portion around the ball end you push it on tight. So that it now rests like that and once that's on and this part is exposed.

Why won’t my gas struts compress?

If your gas strut will not compress you need to let more gas out of it. The pressure is too high for the strut to compress under the weight of the door. If all the gas has been released out of the strut and it still won’t compress it is likely that your struts have been overextended.

How do you remove knuckle struts?

Remove the pinch bolt holding the knuckle to the strut. It won’t hurt anything to tap a screwdrive (that you don’t care about) or a cold chisel into the gap to spread it a bit. A few whacks, perhaps helped with some PB blaster or your favorite penetrating oil around the joint, should help pop it loose.

Is it hard to replace rear struts?

Like replacing shocks and struts. It’s not a job that you should attempt if you’re not familiar working with vehicles, but with a little training and experience, you’ll be ready to tackle the job. In most cases, it shouldn’t take more than a couple of hours to get back on the road again.

What are strut mounts?

As the name (strut mount) implies, it’s a component that attaches the suspension strut to the vehicle. In addition, it insulates the tire noise & vibrations from the vehicle. Many (front) strut mounts also contain a bearing or bearing plate that serves as the steering pivot. A strut mount is like a sandwich.

What holds a strut in place?

A top strut mount connects the strut to the vehicle’s body or frame. Strut mount in a MacPherson strut. In many cars, you can see the front top strut mounts under the hood (see photo below).

What are adjustable strut top mounts?

Adjustable strut top mounts are extremely useful for owners who are planning to run their vehicles at the track, as it allows drivers to adjust wheel camber.

What is a photo strut mount?

High quality Photo slip-in Strut Mounts, available in a wide range of colours and sizes. Suitable for portrait and landscape photographs, simply slip in your photo for a professional look.

What are photos in mounts?

Photographic mounting describes a process of using adhesive to fix a photo print to a solid rigid material, known as a substrate.